Diamond wire saws need to cut diverse rather tough ores for a long term. If the operation is unsuitable or the preliminary instruction and upkeep paintings isn't always done nicely, it's miles commonplace for diamond twine saws to interrupt. There are two major styles of damaged ropes: one is that the two ends of the joint are broken, that's called joint damaged rope; the opposite is that the center section of the wire rope out of doors the joint is broken, that is referred to as broken rope. The following is an analysis of the reasons and solutions for the broken rope of diamond twine saws.


1. Limited by the life of the wire rope, the wire rope is susceptible to fatigue fracture below the premise of alternating load at some point of use; Solution: Reduce the usage of variable load twine saws, and at the identical time, apprehend the existence of the wire rope and update it in time. 2. Due to the manufacturer's reasons, the beads aren't constant firmly, and the beads rotate or circulate. After the beads rotate, the wire rope will wear out in a brief time. The broken twine rope after motion is exposed and loses safety, in an effort to also cause the twine rope to break prematurely; Solution: Stabilize the injection molding high-quality and ensure that the beads do now not rotate or circulate. The rope saw must be checked in time after every slicing. If the beads rotate occasionally, they should be hammered and broken. 3. Due to gadget motives, the rope noticed is unstable and frequently shakes, which could without problems result in rope breakage inside the center and frequent joint breakage; Solution: Choose high-precision machines, maintain them properly for the duration of use, make sure machine performance, boom the stableness of rope noticed operation, and decrease shaking.


4.After the injection molding rope saw is used for a certain time frame, a few cooling water and chips could be injected between the plastic and the twine rope. If it is parked for too long, the cord rope will rust and grow to be brittle, and the twine rope will wreck upfront inside the middle; Solution: Do not park the used rope noticed for too lengthy, together with greater than 1/2 a 12 months. .

5.Customers unilaterally pursue slicing performance and force cutting, resulting in excessive arc of the rope noticed and excessive tension, which in turn causes the cord rope to break; Solution: Reduce the amount of slicing and modify it to mild. 6. If the joint is buckled too tightly, it'll growth the damage to the wire rope and reason the cord rope to break upfront on the joint. Solution: Moderate compression to lessen harm to the cord rope.